How do I properly maintain my machine?

Engraving machine if it is in the operation period, should be in the longest three days time, the guide rail, rack, screw on the dust, mud and sand to organize once, and brush on the guide rail oil, (stop the use of grease).

Regularly organize the screw, to avoid foreign objects sticking on the screw, the screw is very important in the equipment, he resolved the accuracy of the machine, and the screw also plays an important role in the transmission process. After the operation should be timely to organize the table, which will give the stone engraving machine next operation to provide convenience. Organize the guide rail and the material around the guide rail chip, in order to avoid due to the debris interference caused by the machine in the process of operation presents card machine.

　　On the oil after adding oil slowly back and forth to ensure that the lubricant can be evenly added to the guide and screw.

　　If the machine is not used for a long time, it should be refueled regularly to ensure the flexibility of the transmission system. The first clean guide rail and screw, you can use a cloth (not hair) to guide rail and screw on the oil and material debris to organize away. Because of the low temperature, can be added to the rail and screw oil, the best plus anti-freeze oil. Refueling cycle is twice a month, that is, every two weeks to add oil.

　　Often check the dustproof, waterproof function, look at the dust cloth has no wear and tear, if there is wear and tear, water, mud, dust can be through the dust cloth directly splashed to the guide rail, rack, if the work is not particularly busy, should be suspended immediately, and contact with the manufacturer, the procurement of new dust cloth for replacement, and the carving process, the cutter head can be used in the carving process.

　　In the carving process, the cutter head needs to add water for cooling, in the process of adding water, cooling water should be directed at the cutter head spray, not to the handle spray, to the handle, can form the spindle into the water short circuit.

　　Every six months time to check the X, Y-axis belt wear status, if the wear is more serious stone engraving machine, should be purchased from the manufacturer of the belt, to replace.

　　Stone engraving machine circulating water in the tank, according to the amount of work, and the concentration of sediment in the water, should be replaced in 2-3 days, to avoid circulating water pump due to excessive sediment blockage.

　　Temperature when the machine is not necessary, if the room temperature is low, the best pour out the water in the tank, to avoid freezing and cracking the water tank and water pipes.

　　Ensure that the ambient temperature of the operating room, stone engraving machine best to reach room temperature, at least the operator will not be very cold. Check the applicable temperature of the fuel specification, at least to the minimum temperature. Temperature on the stone engraving machine is not a big impact, but because the user to the screw with grease, winter also forgot to organize, resulting in every time the boot running not open, some of the operating room temperature is very low, despite the addition of oil, can still be frozen, the machine does not run.