Laser Cutting Machine Winter Frost Prevention Are What Tips

Laser cutting machine winter frost prevention are what tips

The basic principle of laser cutting machine antifreeze is to make the coolant in the laser cutting machine not reach the "freezing point". Specifically, there are several ways to list them one by one.

Method 1: laser cutting machine does not work after not turning off the water cooler.

After the laser cutting machine does not work to ensure that the power supply will not be cut off in the case (power outage), do not turn off the water cooler. So that the coolant has been in the circulation flow state, while the conventional temperature can be adjusted to about 10 ℃. This coolant temperature does not reach the freezing point, so it will not damage the laser cutting machine.

Method 2: Empty the coolant in the laser cutting machine

Empty the coolant inside each part of the equipment through the drainage port of the laser cutting machine. And inject pure gas to ensure that there is no coolant in the entire water circulation cooling system. This will also ensure that the laser cutting machine will not be harmed by the low temperature.

Method 3: Replace the coolant in the laser cutting machine

In winter, the car running on the road will replace the winter antifreeze, and the equipment can also be added to the car antifreeze. But be sure to choose a big brand of antifreeze, or antifreeze contains impurities, sticking in the laser and other parts of the pipeline will also cause damage to the equipment. Antifreeze can not replace the pure water ionized water as a year-round use. It must be replaced in time after the winter.

The above methods play a very important role in the normal work of laser cutting machine and equipment safety in winter. It is recommended to use the first two methods. Method one saves time and effort, but if you encounter sudden power outages may cause damage to the laser cutting machine. Method two is quite laborious and waste of resources. But it is relatively safe and effective compared to the other two methods.

Warm reminder:

In the second year, before the laser cutting machine began to operate, start the mechanical equipment, check the whole machine, all kinds of oil, coolant with or without missing compilation, to make up for the replacement in a timely manner, deterioration to identify the cause. To better improve the use of laser cutting machine efficiency.