Stone engraving machine tool use guide

Stone engraving machine acrylic cutting process, recommended the use of single-edged spiral milling cutter, featuring smoke-free and odourless processing, fast speed, high efficiency, non-stick chips, truly environmentally friendly, its special manufacturing process to ensure that the processing of acrylic does not burst the mouth, very fine grain (or even no grain), the surface is clean and flat.Processing surface needs to achieve a frosted effect, recommended the use of double-edged three-edged spiral milling cutter.

Stone engraving machine density board cutting processing (advertising moulding), recommended the use of double-edged large chip-excluding spiral milling cutter, which has two high-capacity chip removal groove, double-edged design, both have a very good chip removal function, but also to achieve a very good balance of the tool in the processing of medium and high density board, do not blacken, do not cap the smoke, long service life and other characteristics.

Stone engraving machine aluminium cutting processing, recommended the use of single-edged special aluminium milling cutter.Processing process does not stick to the knife, fast speed, high efficiency.

Stone engraving machine on the following burr-free cutting process, the recommended use of single-edged, double-edged upper and lower cutting milling cutter.

Stone engraving machine metal engraving processing, recommended use of single-edged, double-edged straight groove flat-bottomed sharp knife.

Stone carving machine 3D carving knife, high concentricity, sharp edge, can do precision 3D carving processing.

Stone engraving machine high density board, solid wood recommended the use of prismatic milling cutter.

Stone engraving machine multi-layer board, plywood processing, recommended the use of double-edged straight groove milling cutter.

Stone engraving machine precision small relief processing, recommended the use of round bottom cutter.

Stone engraving machine cork, density board, raw wood, PVC, acrylic large deep relief processing, the recommended use of single-edged spiral ball end milling cutter.

Stone engraving machine under the use of cutting knife effect, the processing of products on the surface without burrs, processing will not be warped.

Stone engraving machine metal mould processing cutter, recommended use of tungsten steel cutter, surface plating purple-black hardened titanium.

Stone engraving machine acrylic mirror engraving processing recommended use of diamond engraving knife.

Stone engraving machine roughing particle board and other recommended use of multi-stripe milling cutter.