What are the safety matters that must be noted when using the engraving machine?

The blade of the carving knife is very sharp, and you can't touch the blade part when you are loading and unloading the knife, so as not to hurt your hand.

The various rotary motion parts of the machine can not be touched during the movement, including the spindle, tool and other parts. Especially high-speed rotary body, it is difficult to judge from the appearance of whether the operation, in the operation of these parts, must first carefully confirm its working condition.

Machine three-axis linear motion, including the movement of the beam along the X-axis, carriage movement along the Y-axis (beam), spindle movement up and down along the Z-axis, these moving parts of high speed, inertia, any personnel should not be close to these parts to avoid collision or extrusion.

In the process of machining, the tool may break, chips, small workpieces may also fly out, be sure to use the dust cover protection device.

Pay attention to the safety cordon of the machine. In order to prevent the engraving machine in operation on the life and health of personnel may cause injury, must be installed at the same time as the equipment to set up a safety cordon.

Safety cordon is pasted on the ground, it and the machine's minimum distance in the front and rear direction of 0.2 meters, 1 meter, left and right 0.6 meters. No one can cross the safety line while the machine is in operation.