What should I pay attention to the safe operation of woodworking engraving machine?

What should I pay attention to the safe operation of woodworking engraving machine?

Before operation, check whether the handle of each part of the woodworking engraving machine is normal, fill lubricating oil according to regulations, and low-speed test run for 1~2 minutes before operation.

Before work should wear good work clothes, female workers should wear a work cap, operation is strictly prohibited gloves.

Clamping workpiece should be stable.

Loading and unloading, knife, measurement, speed change, tighten the mandrel and clean the machine tool, must be in the carving machine spindle stopped.

Woodworking engraving machine table prohibit the placement of tools, workpieces and other debris.

Woodworking engraving machine start, should check the workpiece and milling cutter mutual position is appropriate.

Woodworking engraving machine automatically go knife, the table can not go to two limit position, limit block should be placed firmly.

When the wood engraving machine is running, it is forbidden to clean the machine tool with bare hands or cotton gauze, and the person can not stand in the direction of the tangent line of the milling cutter, not to mention blowing chips with the mouth.

Cutter bar, tie rod, collet and cutter to be installed and tightened before power on, shall not use the woodworking engraving machine spindle rotation to help loading and unloading.

After use should turn off the power, clean the machine tool, and the engraving machine operating handle in the empty position, the worktable moved to the center.