What should I pay attention to when using a small woodworking engraving machine?

After the carving position, must be X, Y, Z axis workpiece coordinates all to "0".

Adjust the carving speed and spindle motor speed, in order to prevent the carving speed is too fast, too slow and break the knife.

Automatic knife, pay attention to the knife block must be insulated with the engraving machine aluminium table.

Carving, if the first knife is not sure or fear of error, you can slow down the speed of the feed knife, feel normal carving and then adjust the speed back to normal; you can also simulate the carving in the empty range to see if it is normal.

If you do not use woodworking engraving machine for a long time, should be regularly refuelled weekly idle, preferably every week, to ensure the flexibility of the drive system.

The requirements of woodworking engraving machine continuous execution time of 10 hours / day or less; to ensure that the cooling water is clean and the normal operation of the pump, never make the water-cooled spindle motor water shortage phenomenon, regular replacement of the cooling water to prevent the water temperature is too high, back to the circle of the water as much as possible, you can change the large-capacity water tank.

Every time you finish using woodworking engraving machine, pay attention to clean up.

Must be the platform and the drive system on the dust cleaned up; regular lubrication of the drive system X, Y, Z three-axis refuelling.

The operator is best in the operation of woodworking engraving machine to wear a dust mask and protective glasses, in order to avoid the processing of dust produced by the invasion of the human body, resulting in discomfort.

Woodworking engraving machine daily maintenance methods in woodworking engraving machine plus a certain amount of dust removal devices, select the dust removal equipment supporting the use.