The operator follows the following sequence of switching on and off the machine every day:(1) Start the air compressor and air dryer;(2) Start the machine control cabinet; start the plasma power supply;(3) Start the programme for cutting after setting all parameters;(4) Switch off all power and air

In general, when the working air pressure is lower than the required air pressure value of the equipment, the air compressor input air flow is less than the specified value, the plasma arc will be weakened at this time, and then can not form a high-energy, high-speed plasma arc, resulting in poor qu

The plasma cutting used in the market will choose different working gases according to the different cutting materials, of which the most widely used is air plasma cutting.Here you need to use plasma cutting supporting air compressor to assist the use of plasma cutting machine, then about the choice

1. Correct torch assemblyFit the torch correctly and carefully, making sure that all parts fit together well and that the gas and cooling air circulates.Installation Place all parts on a clean flannel to avoid dirt sticking to the parts.2、Consumable parts should be replaced in time before they are c

Safety Measures for Plasma Cutting MachinesWhen using a plasma cutter, ensuring safety is a top priority. Here are some key safety measures and recommendations to ensure safety during operation:Grounding and protection against electric shock: The plasma cutter must be grounded for safety. All compon